Module ECU Bosch MEDC17 TC17XX BENCH (J2534)

Module for reprogramming ECU Bosch MEDC17 TC17XX BENCH (J2534)

Functions:
Read FLASH
Write FLASH
Read EEPROM
Write EEPROM

Identification
Checksum Correction

ECU Password Auto-Detection
Processor Type Auto-Detection

Additional Immobilizer OFF function, BOSCH EDC17/MED17 ECU
Additional T-Prot OFF function, BOSCH EDC17/MED17 ECU


The module is designed for reading and writing ECUs on a bench, without opening the ECU.

The module can only operate with a direct connection to the ECU using the J2534 Scanmatic 2/2Pro.

Procedure for working with the ECU:
Remove the ECU from car.
Connect the ECU on bench.
Perform the necessary operations (reads and writes).
Install the ECU in car.
Connecting to the ECU:

Connection to the ECU requires signals from the J2534 adapter (CAN-H = 6Pin, CAN-L = 14Pin, GPT1 = 1Pin, GPT2 = 2Pin, L-Line = 15Pin).
A 120 Ohm resistor is required between the CAN-H and CAN-L signals.

The L-Line is used to control the automatic power supply.




ECUFLASH TOOL is a program designed for working with electronic units in Volkswagen, Skoda, Ford, Mazda, Mitsubishi, Nissan/Infiniti, Subaru, Honda/Acura, Hyundai/Kia, Renault, Toyota/Lexus, Citroen/Peugeot, and other vehicles.

To work with the Program, you need a J2534 adapter, such as OpenPort 2.0, Mongoose, CarDaq, Scanmatic 2, Scanmatic 3, Chipsoft.

The software is delivered modularly. A SenseLock key is used to protect the software. If you don't have a USB key, you must purchase USB key, as the module will not function without one. If you have a USB key, please enter USB key number when placing your order.